Search found 188 matches
- Mon Jul 06, 2015 8:06 pm
- Forum: Lambretta Tech
- Topic: Mec 60/100 crank recovery options
- Replies: 10
- Views: 3635
Re: Mec 60/100 crank recovery options
On mine it seems to be the full circle where the clearance is minimal, that what left me confused! Others have said that a small amount needs to be removed at the mouth which I expected and was prepared to do, but I can't get it to spin freely at all hence the need remove more material. I intended t...
- Mon Jul 06, 2015 7:42 pm
- Forum: Show us yer Scoots!!
- Topic: Deleted
- Replies: 0
- Views: 1299
Deleted
Post deleted, couldn't get it to work
- Mon Jul 06, 2015 3:19 pm
- Forum: Lambretta Tech
- Topic: Mec 60/100 crank recovery options
- Replies: 10
- Views: 3635
Re: Mec 60/100 crank recovery options
Depending on the advice I was intending to pay the local machine shop to have 0.2-0.5mm machined out but I really need to know what's an adequate clearance
- Mon Jul 06, 2015 2:48 pm
- Forum: Lambretta Tech
- Topic: Mec 60/100 crank recovery options
- Replies: 10
- Views: 3635
Re: Mec 60/100 crank recovery options
Unfortunately it's not that, the diameter of the crank + extra bit caused by the Conrod is too big for the diameter of the casting.
I either reduce the diameter of the crank or increase the casing diameter.
I either reduce the diameter of the crank or increase the casing diameter.
- Mon Jul 06, 2015 1:40 pm
- Forum: Lambretta Tech
- Topic: Mec 60/100 crank recovery options
- Replies: 10
- Views: 3635
Re: Mec 60/100 crank recovery options
on the crank casing and the webs show marking after rotating the crank
- Mon Jul 06, 2015 1:12 pm
- Forum: Lambretta Tech
- Topic: Mec 60/100 crank recovery options
- Replies: 10
- Views: 3635
Mec 60/100 crank recovery options
My shiny new Mec 60mm/110 rod Crankshaft doesn't seem to fit inside my 125 crankcase. The main issue seems to be the con rod sticking out the webs by approx 1.6 mm, the clearance between the crank case and the Conrod when spun is less than 0.02mm (feeler gauge). The webs seem to be rubbing a little ...
- Sat Jul 04, 2015 5:26 pm
- Forum: Lambretta Tech
- Topic: Which Kit??
- Replies: 48
- Views: 15374
Re: Which Kit??
I have just been through the same issue and here is some advice that Corrado,provided on another site In order of state of tune you can go from Casa 186, Mugello, RT, GT, Imola, Casa SS, RB20. All top quality kits and they'll all do what it says on their tins. No such thing as a bad kit these days [...
- Mon Jun 29, 2015 5:07 pm
- Forum: Lambretta Tech
- Topic: Supertourer port timings
- Replies: 6
- Views: 4516
Re: Supertourer port timings
[quote][ Re: Supertourer port timings Post by eden » Tue Jun 23, 2015 6:02 pm with just 22 degrees blow down that exhaust wont work as you say "properly"/quote] As I'm pretty new to matching exhausts and cylinders, can you explain why this doesn't work? & What pipe would work with that...