Search found 106 matches
- Wed Apr 29, 2015 1:43 pm
- Forum: Lambretta Tech
- Topic: LT Coil and Pickup
- Replies: 1
- Views: 731
LT Coil and Pickup
I need to change both on the stator. Cheap and cheerful SIL or is it worth pushing the boat out for MB? Any other recommendations??
- Mon Apr 27, 2015 11:19 am
- Forum: Lambretta Tech
- Topic: RT195 W/PWK 28, starting difficulties only after short brake
- Replies: 14
- Views: 5102
Re: RT195 W/ PWK 28, difficulties after short brake
I'd also add that I gave up on the remote filter as well and now run a Ramair filter through the side panel. This is not always an option I know but it definitely helps...
- Mon Apr 27, 2015 11:08 am
- Forum: Lambretta Tech
- Topic: RT195 W/PWK 28, starting difficulties only after short brake
- Replies: 14
- Views: 5102
Re: RT195 W/ PWK 28, difficulties after short brake
My RT200 sometimes does the same and it's definitely spit back. As I've got the jetting closer this doesn't happen so often now. Butt if I brake heavily and stall it will. If I stop for petrol say, I'll turn the fuel off and burn a bit off before shutting down the engine. It will then usually kick f...
- Wed Apr 22, 2015 9:13 am
- Forum: Lambretta Tech
- Topic: Ts1 misfire ?
- Replies: 1
- Views: 1591
Re: Ts1 misfire ?
I had a similar problem recently which came to a head after completing the Coast to Coast this weekend. We suspect it's the LT Coil on the stator plate although I've not stripped it down yet. But it's the prime suspect...
- Thu Apr 16, 2015 8:03 am
- Forum: Lambretta Tech
- Topic: Kickstart problem
- Replies: 2
- Views: 1352
Re: Kickstart problem
None taken. The piston isn't new, it's an old one that has been re-ground. Not sure if the photo does it justice but it's fine. There is an old bump stop in the case, it's just worn out! I will get a new one, just haven't had time! The pin was the original one that was in and I probably should have ...
- Tue Apr 14, 2015 11:28 pm
- Forum: Lambretta Tech
- Topic: Kickstart problem
- Replies: 2
- Views: 1352
Kickstart problem
I've sorted this problem but thought I'd post a few photos for future reference in case your tempted to ignore your kickstart slipping... Before xmas the kickstart failed to return to the bump stop by a couple of inches. I simply rotated it a couple of splines and just carried on as normal. But on a...
- Wed Mar 25, 2015 2:29 pm
- Forum: Lambretta Tech
- Topic: 30mm Delorto carb idle mix screw?? (and jets)
- Replies: 8
- Views: 6169
Re: 30mm Delorto carb idle mix screw?? (and jets)
I run 118 main on my RT200 with a 28mm PHBH. All other jets similar apart from 48 idle. Ramair filter to bellmouth. I'm currently on 1 turn out... running very nicely...
- Mon Mar 09, 2015 9:49 am
- Forum: General Scooter Chat
- Topic: in line fuel filter
- Replies: 6
- Views: 2278
Re: in line fuel filter
I used the square disposable one from MB last year, mainly because I didn't know what was in the tank. After 1400 miles I reckon anything nasty would have come through by now. I took it off during winter tinkering and the main difference I noticed was it starts easier! Even with the filter on I stil...
- Sat Feb 21, 2015 9:50 pm
- Forum: General Scooter Chat
- Topic: New skid lid time...
- Replies: 47
- Views: 13831
Re: New skid lid time...
That's right, especially around the cheeks...Bert Oni wrote: So in summary, for your helmet you have ... Ahem...a "pump system that makes it a good snug fit"....
- Fri Feb 20, 2015 9:38 pm
- Forum: Tech FAQ
- Topic: Jumps out of 2nd gear
- Replies: 10
- Views: 6825
Re: Jumps out of 2nd gear
Sliding dog? I had this problem and it slowly got worse to the point it was jumping between gears with the clutch pulled in at a standstill... to point it was stripping the trunnion off the cable. I got new selector arm, set and reset cables etc but it wasn't until we got inside that the problem bec...