Search found 486 matches

by jason frost
Wed Mar 22, 2017 9:18 am
Forum: Lambretta Tech
Topic: Pic of LH rear frame leg- S3?
Replies: 18
Views: 1989

Re: Pic of LH rear frame leg- S3?

Leg just needs to come out abit , give it a hit from behind with a rubber mallet , it may then need to go forward or backward , just give it a hit from the side , keep no until it fits :)
by jason frost
Thu Mar 02, 2017 11:20 pm
Forum: Lambretta Tech
Topic: What is the recommended piston to bore clearance?
Replies: 13
Views: 2058

Re: What is the recommended piston to bore clearance?

What make of piston is it ?
by jason frost
Sat Dec 24, 2016 11:52 pm
Forum: General Scooter Chat
Topic: Thank You
Replies: 10
Views: 2088

Re: Thank You

And as a dealer , a big thank you to all the customers that keep us going
by jason frost
Mon Dec 12, 2016 8:29 pm
Forum: Lambretta Tech
Topic: DIy cheap thumb choke conversion
Replies: 14
Views: 2094

Re: DIy cheap thumb choke conversion

I use the gear change off a push bike , they have a few clicks on them so you can just open it a bit at a time and leave it
by jason frost
Mon Oct 17, 2016 8:23 pm
Forum: Lambretta Tech
Topic: Race Tour Pistons
Replies: 34
Views: 6692

Re: Race Tour Pistons

All the ones I've built have been fine so far. I run a tuned RT 225 on my own bike , just had it to bits and it's fine.
by jason frost
Sun Oct 16, 2016 7:17 pm
Forum: Lambretta Tech
Topic: Seized Stage 4 steel barrel
Replies: 12
Views: 1981

Re: Seized Stage 4 steel barrel

What's the piston ? Any tuning ? Piston to bore clearance ?
by jason frost
Sun Mar 13, 2016 8:50 pm
Forum: Lambretta Tech
Topic: flywheel pick-up alignment
Replies: 6
Views: 1575

Re: flywheel pick-up alignment

Muppet wrote:window marks are a waste of time make your own tdc and timing marks on the mag then strobe
;)
New flywheel you will need to set new timing marks and check them with a timing light
by jason frost
Thu Feb 25, 2016 11:49 am
Forum: Carburettor Set-ups
Topic: RT195/30mm PHBH/BGM clubman set up.
Replies: 9
Views: 3931

Re: RT195/30mm PHBH/BGM clubman set up.

Try a X7 needle and a 120 main to start and come down from there
by jason frost
Mon Oct 19, 2015 12:48 pm
Forum: Lambretta Tech
Topic: Electronic ignition conversion - AC or DC?
Replies: 13
Views: 2581

Re: Electronic ignition conversion - AC or DC?

Fit the DC one and wire it up to the reg to run AC , then if at a later date you want to go full DC you can without having to take the stator off.
by jason frost
Mon Sep 28, 2015 8:04 pm
Forum: Lambretta Tech
Topic: Christmas tree bearing track
Replies: 10
Views: 1460

Re: Christmas tree bearing track

Or weld a nut in to it and use a bolt to pull it put