Search found 65 matches
- Sun May 31, 2009 8:09 am
- Forum: Show us yer Scoots!!
- Topic: Dead RB kit
- Replies: 31
- Views: 8256
Re: Dead RB kit
Don't worry its not bad luck just bad design.(exhaust port) the original drawings set the bridges at 4mm min wide, but they were cast much thinner. This is a trade secret which i think we should all know about. Why do you think the RB20 is a real good kit(no bridges)
- Mon May 18, 2009 12:58 am
- Forum: Lambretta Tech
- Topic: Jimmers/taffspeed reed inlet manifold
- Replies: 2
- Views: 2191
Jimmers/taffspeed reed inlet manifold
Here are two inlet manifolds i machined up for a 205 special, one use's a TS1 reed block the other an RD 350 reed block, will never fit under panels but the nuts on a cutdown or skelly.Carb used 35 TMX (TSI reed ) 28TM (RD 350 reed) http://i8.photobucket.com/albums/a9/ScooterLoopyJohn/reed%20inlet/I...
- Thu Apr 23, 2009 6:59 am
- Forum: Lambretta Tech
- Topic: Offset Cones
- Replies: 13
- Views: 3491
Re: Offset Cones
From the ones i measured before makeing any, all are simular as to the angle / outer face pos. The champher is to aid the mounts over them on assembly. as the early ones are so easy to knock out on assembly, must have been a sod on the production line hence the mod. are you sure the cone faces in th...
- Wed Apr 22, 2009 7:21 am
- Forum: Lambretta Tech
- Topic: Offset Cones
- Replies: 13
- Views: 3491
Re: Offset Cones
I have not had an issue with my offset cones(but if you have then i can sort it) mine are done on a cnc lathe and checked for size every 10 to keep identical. some others i have seen are a bit rough to say the least. i sell under the name big-bad-barry.
- Sat Jan 17, 2009 9:09 am
- Forum: Scooterotica Tuning & Maintenance Information
- Topic: Mikuni TMX 35 needles explained
- Replies: 1
- Views: 8271
Mikuni TMX 35 needles explained
This has helped me and i think should help all of you, complied by James Pennington (Australia). Mikuni TMX35 needles All TMX35 needles are of 6EN11 pattern. 6 signifies needles between 60mm and 70mm long (all 66.3mm long in this series) E represents the total included angle of the first taper (1.25...