Search found 182 matches

by db67
Thu Dec 23, 2021 8:09 pm
Forum: Lambretta Tech
Topic: GT186 --EX box any one running one
Replies: 7
Views: 9522

Re: GT186 --EX box any one running one

I've got them on both my ts1 225's & can't fault them , bags of torque , I don't think you will be disappointed if you purchase one ;)
by db67
Wed Oct 20, 2021 12:03 pm
Forum: Lambretta Tech
Topic: Need a 2.5mm head gasket.. Source?
Replies: 3
Views: 2671

Re: Need a 2.5mm head gasket.. Source?

Cambridge Lambretta ?
by db67
Sun Jun 06, 2021 5:32 pm
Forum: Lambretta Tech
Topic: Rear hub nut
Replies: 5
Views: 2928

Re: Rear hub nut

Try comparing it to the old nut if you have one available.
by db67
Tue May 18, 2021 12:06 pm
Forum: Lambretta Tech
Topic: Standard exhaust
Replies: 8
Views: 3748

Re: Standard exhaust

As long as its suitable for a 200 ;)
by db67
Mon May 17, 2021 7:25 pm
Forum: Lambretta Tech
Topic: Standard exhaust
Replies: 8
Views: 3748

Re: Standard exhaust

40mm SIL Clubman I believe.
by db67
Fri May 14, 2021 7:34 pm
Forum: Lambretta Tech
Topic: Standard pipe thoughts
Replies: 4
Views: 1625

Re: Standard pipe thoughts

Ron Moss Avanti ex box , best clubman i've run ;)
by db67
Sat May 01, 2021 6:42 pm
Forum: Lambretta Tech
Topic: starting a sil lambretta after 2 years
Replies: 5
Views: 1991

Re: starting a sil lambretta after 2 years

Take the plug out, check you have a spark , drop a little bit of 2 stroke down the plug hole,kick it over a few times then put the plug back in, strip & clean the carb, drain any fuel out the tank & refill with fresh petrol & then you should be good to go for a start up👍
by db67
Sun Apr 25, 2021 1:39 pm
Forum: Lambretta Tech
Topic: 200 lost tickover and harder to start
Replies: 5
Views: 2546

Re: 200 lost tickover and harder to start

Air leak? could be several things that have come loose :- inlet manifold, exhaust downpipe, cylinder head, carb,spark plug or something a lot simpler like a split air hose rubber? fuel flow , blocked tap/filter , float sticking? or the tick over screw has wound itself out. Good luck ;)
by db67
Sun Apr 18, 2021 4:26 pm
Forum: Lambretta Tech
Topic: Sip speedo worm drive sensor cable settings
Replies: 0
Views: 3771

Sip speedo worm drive sensor cable settings

Just wondered if anyone had any of the settings for the following adjustments using the worm gear drive sensor cable :- I've set my tyre circumference to 1304 , this is after measuring 10 rotations of the wheel, drive ratio setting is at 0.7p & pulse setting is 3 , are these about right? just tr...
by db67
Tue Apr 06, 2021 7:50 pm
Forum: Lambretta Tech
Topic: Lambretta sip digital speedo GPS
Replies: 0
Views: 3900

Lambretta sip digital speedo GPS

Hi, just ordered a gps module for my sip digital speedo & just wondered if anyone is running one & if so where is the best place to mount the GPS module in order to receive the best signal. thanks for any info. Cheers db