Search found 182 matches
- Thu Dec 23, 2021 8:09 pm
- Forum: Lambretta Tech
- Topic: GT186 --EX box any one running one
- Replies: 7
- Views: 9791
Re: GT186 --EX box any one running one
I've got them on both my ts1 225's & can't fault them , bags of torque , I don't think you will be disappointed if you purchase one
- Wed Oct 20, 2021 12:03 pm
- Forum: Lambretta Tech
- Topic: Need a 2.5mm head gasket.. Source?
- Replies: 3
- Views: 2746
Re: Need a 2.5mm head gasket.. Source?
Cambridge Lambretta ?
- Sun Jun 06, 2021 5:32 pm
- Forum: Lambretta Tech
- Topic: Rear hub nut
- Replies: 5
- Views: 3024
Re: Rear hub nut
Try comparing it to the old nut if you have one available.
- Tue May 18, 2021 12:06 pm
- Forum: Lambretta Tech
- Topic: Standard exhaust
- Replies: 8
- Views: 3843
Re: Standard exhaust
As long as its suitable for a 200
- Mon May 17, 2021 7:25 pm
- Forum: Lambretta Tech
- Topic: Standard exhaust
- Replies: 8
- Views: 3843
Re: Standard exhaust
40mm SIL Clubman I believe.
- Fri May 14, 2021 7:34 pm
- Forum: Lambretta Tech
- Topic: Standard pipe thoughts
- Replies: 4
- Views: 1661
Re: Standard pipe thoughts
Ron Moss Avanti ex box , best clubman i've run
- Sat May 01, 2021 6:42 pm
- Forum: Lambretta Tech
- Topic: starting a sil lambretta after 2 years
- Replies: 5
- Views: 2045
Re: starting a sil lambretta after 2 years
Take the plug out, check you have a spark , drop a little bit of 2 stroke down the plug hole,kick it over a few times then put the plug back in, strip & clean the carb, drain any fuel out the tank & refill with fresh petrol & then you should be good to go for a start up
- Sun Apr 25, 2021 1:39 pm
- Forum: Lambretta Tech
- Topic: 200 lost tickover and harder to start
- Replies: 5
- Views: 2612
Re: 200 lost tickover and harder to start
Air leak? could be several things that have come loose :- inlet manifold, exhaust downpipe, cylinder head, carb,spark plug or something a lot simpler like a split air hose rubber? fuel flow , blocked tap/filter , float sticking? or the tick over screw has wound itself out. Good luck
- Sun Apr 18, 2021 4:26 pm
- Forum: Lambretta Tech
- Topic: Sip speedo worm drive sensor cable settings
- Replies: 0
- Views: 4012
Sip speedo worm drive sensor cable settings
Just wondered if anyone had any of the settings for the following adjustments using the worm gear drive sensor cable :- I've set my tyre circumference to 1304 , this is after measuring 10 rotations of the wheel, drive ratio setting is at 0.7p & pulse setting is 3 , are these about right? just tr...
- Tue Apr 06, 2021 7:50 pm
- Forum: Lambretta Tech
- Topic: Lambretta sip digital speedo GPS
- Replies: 0
- Views: 4097
Lambretta sip digital speedo GPS
Hi, just ordered a gps module for my sip digital speedo & just wondered if anyone is running one & if so where is the best place to mount the GPS module in order to receive the best signal. thanks for any info. Cheers db