Search found 460 matches

by dirtyhandslopez
Mon May 27, 2019 4:57 am
Forum: General Scooter Chat
Topic: Crikey its quiet in here ..iet in here...in here... here..
Replies: 57
Views: 2827

Re: Crikey its quiet in here ..iet in here...in here... here..

So 39mm from the top of the exhaust port to the the top of the cylinder isn't optimum any more?
by dirtyhandslopez
Sun May 19, 2019 2:32 am
Forum: Lambretta Tech
Topic: Help Understanding stator test results.
Replies: 7
Views: 657

Re: Help Understanding stator test results.

Just to throw this out there... Is the magnetism good in the BGM flywheel? I only ask as I did a comparison between an indian flywheel and a BGM flywheel and the Indian flywheel won hands down. Using a spark plug gap tester, the indian flywheel put out a lot bigger spark also. Stands to reason if th...
by dirtyhandslopez
Mon Jul 30, 2018 2:39 am
Forum: Lambretta Tech
Topic: Gear Compatibility
Replies: 23
Views: 2080

Re: Gear Compatibility

Some gears gears just won't fit together correctly, that's all there is to it.
by dirtyhandslopez
Mon Jul 30, 2018 2:29 am
Forum: Lambretta Tech
Topic: Gear Compatibility
Replies: 23
Views: 2080

Re: Gear Compatibility

Some gears gears just won't fit together correctly, that's all there is to it. If you would like to count gears and make up gearboxes, come have at it.
by dirtyhandslopez
Mon Jul 30, 2018 2:03 am
Forum: Lambretta Tech
Topic: New 185cc engine won't start or run
Replies: 29
Views: 2382

Re: New 185cc engine won't start or run

HxPaul wrote:
Tue Jul 24, 2018 11:43 pm
Its not the gasket breaking down,it looks like the float bowl leaked at some time so somebody has put sealer on the gasket.
Absolutely.
by dirtyhandslopez
Mon May 14, 2018 4:12 am
Forum: Lambretta Tech
Topic: Early type layshaft question
Replies: 6
Views: 843

Re: Early type layshaft question

They are a little heavy. Depends what you what your engine to do.. Nothing wrong with them. Weight can be a good thing.

Tourer Bazza?
by dirtyhandslopez
Mon May 14, 2018 3:41 am
Forum: Vespa Tech
Topic: Turn signals on P200e 12 volt USA edition...
Replies: 6
Views: 878

Re: Turn signals on P200e 12 volt USA edition...

Check where the panel front pin goes in. That's ground and those contact areas get dirty sometimes.
by dirtyhandslopez
Thu Dec 21, 2017 4:30 am
Forum: Tech FAQ
Topic: Never seen this before?
Replies: 3
Views: 1354

Re: Never seen this before?

Probably not a dot punch, might distort the piston. More like a drill bit. Nice little oil collector spot. Most just have the cross hatch in a smaller pattern.
by dirtyhandslopez
Thu Dec 21, 2017 4:06 am
Forum: Tech FAQ
Topic: Gear oil vs two cycle mixing oil
Replies: 10
Views: 2511

Re: Gear oil vs two cycle mixing oil

Vespa's run straight 30w in the gearbox. So can Lambrettas, I reckon the chain gets a bit niosey with thin oil, but less drag. 30w can also successfully be used as two stroke, as can most oils if you shake the mix up enough:)
by dirtyhandslopez
Thu Dec 14, 2017 1:42 am
Forum: Lambretta Tech
Topic: Detonation, lean seizure, or....?
Replies: 33
Views: 4338

Re: Detonation, lean seizure, or....?

Was the water cooling up to snuff? Looks like a simple it got hot and seized. If it runs a thermostat in the cooling system, the thermostat might have given up. Timing, 24*, seems high.
.