Search found 71 matches

by Mrnice71
Mon May 20, 2019 8:20 pm
Forum: Lambretta Tech
Topic: Readspeed Lukas CDI
Replies: 6
Views: 275

Re: Readspeed Lukas CDI

Ok cheers guys
by Mrnice71
Sun May 19, 2019 7:04 pm
Forum: Lambretta Tech
Topic: Readspeed Lukas CDI
Replies: 6
Views: 275

Re: Readspeed Lukas CDI

Dont quite understand you there Paul ? Do you mean regulate the power coming from the CDI unit ?
by Mrnice71
Sun May 19, 2019 1:53 pm
Forum: Lambretta Tech
Topic: Readspeed Lukas CDI
Replies: 6
Views: 275

Readspeed Lukas CDI

Do you run the Readspeed Lukas CDI with or without a voltage regulator on A/C ? Cheers
by Mrnice71
Fri May 17, 2019 5:38 pm
Forum: Lambretta Tech
Topic: Wits end ...and past it
Replies: 22
Views: 634

Re: Wits end ...and past it

l would speak to Mark as that bearing may use a different seal , the inner lip sits down and some hub bearings can have a sharp leading edge , also are you using seal grease on assembly as a seal fitted dry will quickly fail as the bearing goes tight once the seal is fitted
by Mrnice71
Fri May 17, 2019 2:29 pm
Forum: Lambretta Tech
Topic: Wits end ...and past it
Replies: 22
Views: 634

Re: Wits end ...and past it

Just because its pre-fitted doesn't mean its fitted correctly , buy a new seal & fit it yourself
by Mrnice71
Fri May 17, 2019 11:21 am
Forum: Lambretta Tech
Topic: Wits end ...and past it
Replies: 22
Views: 634

Re: Wits end ...and past it

The MB hub bearings are known to be crap l would recommend RIV or Casa , what make of seal is it ? l only use Rolf , l can never even fit the pattern ones without damaging them and warm them up a bit when fitting and lots of seal grease
by Mrnice71
Thu May 09, 2019 12:25 pm
Forum: Lambretta Tech
Topic: Jetting
Replies: 11
Views: 619

Re: Jetting

l run a 3.50 mm float valve jet on a 30 mm dellorto flatslide , put the 3.00mm back in or you will have fuel starvation issues .
Air filters are restrictive which will richen up jetting , so try a 135 main jet , let us know how you get on .
by Mrnice71
Thu May 09, 2019 9:22 am
Forum: Lambretta Tech
Topic: Jetting
Replies: 11
Views: 619

Re: Jetting

db67 .....a 200 float valve jet is to small , you need a 300 , what exhaust are you running ? On a standard TS1 a 140 main could be a bit to large
by Mrnice71
Fri May 03, 2019 12:19 am
Forum: Lambretta Tech
Topic: Rear hub oil seal
Replies: 10
Views: 417

Re: Rear hub oil seal

Good thanks for letting us know , just shows cheap Indian seals are useless :roll:
by Mrnice71
Mon Apr 29, 2019 9:40 pm
Forum: Lambretta Tech
Topic: rt 195
Replies: 8
Views: 378

Re: rt 195

A 4 plate should be fine with that set up , the scootopia clutch plates are good with MB springs and rough the steel plates up a bit and putoline SAE 90 gear oil should hold