Scooterotica

keep,er lit

what i do it cut and shap a bit of metal to fit in side the panel and then cut were the split is with a saw and spotweld the plate on the weld the split up to the plate job done
billy

keep,er lit

do you need it welding bilko gives a bell

keep,er lit

bilko are they chrome or s/s if not give me a bell mate

keep,er lit

i am thinking about getting one of thes ones

cgi.ebay.co.uk ws eBayISAPI.dll... K MEWAX IT

keep,er lit

hi i have a runner 125 two stroke with a f##ked engine. got one of ebay for it but it does not have the variator or the clutch with it. the outer caseing are diferent as my engine had the clutch nut on the out side of the caseing and the new one has it on the inside are the variator and clutch inter...

keep,er lit

bilko if they dont fit the vespa runners give me a ring and i sort them out for you mate

keep,er lit

is the horn cover made of fiberglass as i cant see any v line in it
billy

keep,er lit

i used px floor runners for a gp before i set the runner on the floorboards to make it for cutting and welding.

keep,er lit

hi i have a ts1 225 that has a mrb inlet manifold with an outside dia of 40 mm the carb i going to use it a 34 vhsa with an out side dia of 45 mm will it be ok to use a steped carb rubber on it or will i be better of getting a new manifold for it
thanks billy

Search found 9 matches

Re: panel strengthening

Re: Not Again!

Re: Looking a bodge

Re: EGT Guage & Probe

runner engine

Re: Quality Rear Runners

Re: silverware waiting this old girl (owner carlos notts carpet)

Re: Welding advice

ts1 inlet

Login • Register

Advertising