Search found 17 matches
- Tue Mar 09, 2021 9:54 pm
- Forum: General Scooter Chat
- Topic: Regulator
- Replies: 3
- Views: 2962
Re: Regulator
Hi, found one, PM me if still required
- Mon Mar 08, 2021 8:48 pm
- Forum: General Scooter Chat
- Topic: Regulator
- Replies: 3
- Views: 2962
Re: Regulator
Think I have one, will have a look & come back to you.
- Sat Dec 07, 2019 7:35 pm
- Forum: Lambretta Tech
- Topic: Motoplat ignition coil
- Replies: 13
- Views: 6056
Re: Motoplat ignition coil
Also got a couple if Carlos can’t find his
- Tue Dec 03, 2019 9:47 pm
- Forum: Lambretta Tech
- Topic: Motoplat ignition coil
- Replies: 13
- Views: 6056
Re: Motoplat ignition coil
Is it the electronic one or points one you need?
- Thu Dec 20, 2018 8:32 pm
- Forum: Lambretta Tech
- Topic: Scomadi forks
- Replies: 4
- Views: 2806
Re: Scomadi forks
Unfortunately don’t have the old set to try, am fairly confident frame is fine, had it jigged prior to paint?
Will have another go this weekend
Will have another go this weekend
- Tue Dec 18, 2018 8:14 pm
- Forum: Lambretta Tech
- Topic: Scomadi forks
- Replies: 4
- Views: 2806
Re: Scomadi forks
Sorry, yeah PM forks, have fitted loads before with the very little issue, but these will just not push all the way through the steering tube? We’re yours series one’s
- Sun Dec 16, 2018 10:16 pm
- Forum: Lambretta Tech
- Topic: Scomadi forks
- Replies: 4
- Views: 2806
Scomadi forks
Just got round to fitting a set of Scomadi forks into a series one, they are the correct ones, as in the stem length & pinch bolt slot is at the rear rather than the side. However they will not slide fully through the steering column, and seem to stick approx. two inches short. Just wondered if ...
- Sat Oct 31, 2015 10:11 pm
- Forum: Lambretta Tech
- Topic: Is there a correct sequence.....?
- Replies: 7
- Views: 3246
Re: Is there a correct sequence.....?
Just checked old 'official manual' it says- off side, then near side then anchor bolt/nut.
- Sat Oct 31, 2015 9:58 pm
- Forum: Lambretta Tech
- Topic: Is there a correct sequence.....?
- Replies: 7
- Views: 3246
Re: Is there a correct sequence.....?
I also seem to remember reading in one of the older manuals there is a sequence, could be well wrong but seem to recall it was, near side first then the anchor bolt then the off side spindle nut.
Am now off to double check, not sure if/how much difference it actually makes though!
Am now off to double check, not sure if/how much difference it actually makes though!
- Sat Apr 25, 2015 6:48 pm
- Forum: Lambretta Tech
- Topic: Scootrs ignition switch
- Replies: 1
- Views: 1288
Scootrs ignition switch
Hi, anybody got a copy of a wiring diagram to wire in a Scootrs ignition switch? Thanks in advance