Scooterotica

tarmac tickler

make another timing mark directley opposite the one on the flywheel,, ie,, if timing mark is 12 oclock, make one at 6 oclock,,, re strobe and as if like magic you,ll see the new timing mark

tarmac tickler

is it a new crank? last couple of cranks (indian) i have fitted you could put the inner race on and off by hand,, is that your problem, the crank is spinning but the race isnt? also if you heat it up too much,, until its blue, you soften the metal and it will wear alarmingly fast

tarmac tickler

mate of mines seals kept going,, turns out his mag housing has been machined wrong and the hole aint in the middle, thus the bearing is off-set a bit ,,, does yours vibrate? his was undriveable,,

tarmac tickler

couple of year back at cleethorpes rally i was after a couple of new low tension coils to repair a couple of stators,, took my tester with me,, checked the coils on dealers stall and told him 3 out of the 5 he had were no good, readings too low,,, was told i only sell um i dont make um, and he put u...

tarmac tickler

every new crank i fit i check for true,,,, 1 out of 5 are out,,, i s**t u not,,, if you spend money on a new flywheel without outing the crank and getting it checked would be foolish,,, elmec had a spell when they set the boss in the flywheel a rivet out ,,, have had swarf trapped under one side of ...

tarmac tickler

do not use lcgb,, use british lambretta archive loads cheaper only 7 quid and u dont have to deal with arseholes

tarmac tickler

leave the w@nk3r b@5t@rd s**t feedback, wont make any difference but will make u feel a bit better

tarmac tickler

its not the same as mine then, but i can guarantee its got an internal battery

tarmac tickler

internal battery gone,, peel off front sticker to expose four screws, there u will find a battery

tarmac tickler

the piston will destroy itself if u run it like that, guarantee that, i have done it, trust me, scrap the barrel, its pot luck if you get a decent one o those alloy sr copies, you better off getting your iron cylinder bored out to 175cc n do a bit of diy porting

Search found 102 matches

Re: 6000 rpm normal????

Re: magside bearing

Re: non runner

Re: More s**t parts.

Re: Flywheel balance

Re: Registration??

Re: Koso digital tacho help needed

Re: Koso digital tacho help needed

Re: Koso digital tacho help needed

Re: Some fairly dumb timing and engine setup questions.

Login • Register

Advertising