Scooterotica

cit205

Pretty sure you can buy cheap enough clam shell repros ,could drill the rivets out and swap the faces over maybe , or leave a 'dummy' horn on show and fit the ugly one under the mudguard somewhere.

cit205

so he was

someone must have revived the thread , i saw it and posted

cit205

About 18ft/lb

cit205

hi can anyone give me timming and rough jetting for 172 mallossi runing standard carb no porting etc and no autolube exhaust will be pm going to strop and do bearings and seals Leave the timing as standard - but it would be good to strobe it as the standard marks are not necessarily that accurate ....

cit205

all been said before probably but some interesting reminders on here

http://www.frost.co.uk/protect-your-veh ... st-ethanol

cit205

Yes any airleak caused by seal or otherwise ,such as head, carb seating. All the tickover screw does is hold the slide in a certain position to stop it closing right up so you are having that bypassed by the air rushing in somewhere else. The air mixture screw on the back of the carb should be aroun...

cit205

Sounds like an air leak ,could be main oil seal at worse. If you unscrew and take the clutch cover breather out then start the engine ,when it starts screaming by itself put your finger on the clutch breather hole ,if the revs settle down then it's the main seal needing replacing, because when they ...

cit205

cit205

Yes. Wheel off, then 3 m5 or m6 bolts. Take care not to drop the brass plunger down the gearbox .

cit205

Bofs wrote:Splines on rear hub gone? Pop off your hub cap and see if the shaft is spinning when you're in gear.

Sent using Tapatalk

^what he said

Search found 165 matches

Re: DC Horn on old Vespa

Re: Vespa Carb Set-ups.....

Re: torqe setting

Re: Vespa Carb Set-ups.....

Re: Fuel dilema

Re: vespa carb problem advice needed

Re: vespa carb problem advice needed

Re: Tyre rubbing on clutch housing

Re: What's going on?

Re: What's going on?

Login • Register

Advertising