Search found 5 matches
- Sat Nov 01, 2014 5:15 pm
- Forum: Vespa Tech
- Topic: t5 engine
- Replies: 10
- Views: 4813
Re: t5 engine
hi fast frog firstly can i say ive seen your work and its the great work that u do wish i could do half of what u do.right timing is set up at 14 degrees and put a standard malossi base gasket on and was lent a 1.5mm head gasket all bolted up and and me squish if im reading gauge right im getting 1....
- Wed Oct 29, 2014 8:04 pm
- Forum: Vespa Tech
- Topic: t5 engine
- Replies: 10
- Views: 4813
t5 engine
built a new engine for me t5 with a 54mm stroke crank and reed valve with a malossi 172 kit and a mmw head what would be the best packer plate or and head gasget combination to use im asking this before i buy the packer or head gaskets.
- Thu May 20, 2010 2:48 pm
- Forum: Carburettor Set-ups
- Topic: 172 malossi jetting
- Replies: 3
- Views: 3843
Re: 172 malossi jetting
cheers m8.
- Thu May 20, 2010 9:46 am
- Forum: Carburettor Set-ups
- Topic: 172 malossi jetting
- Replies: 3
- Views: 3843
Re: 172 malossi jetting
running 50/1 .main jet 122,pilot jet 55,slide 40,atomiser av266,needle not sure but on second clip and 1 and half turns on mixture screw runs very rich need some help to see if this can be improved . this is the jetting set up as it was when i bought me vespa.so if any one can help will be greatfull.
- Thu May 13, 2010 9:52 am
- Forum: Carburettor Set-ups
- Topic: 172 malossi jetting
- Replies: 3
- Views: 3843
172 malossi jetting
running a 172 malossi with a pm tuning exhaust and a 28mm phbh delorto and no bottom end tune can any one advise a good jetting and air mixture screw setting running with foam air filter.