Search found 6 matches
- Thu Oct 01, 2015 6:28 am
- Forum: Lambretta Tech
- Topic: TS1 jetting advice
- Replies: 5
- Views: 2370
Re: TS1 jetting advice
Similar set up as me. Same carb. I've got a 160 main jet. 55 idle I think X7 needle. Spot on. Ride hard and long with no problems. Nice plug chops. Damp outer chocolate colour dry inner. As it should be.plug chops tell you two things. Outer is the mix. Inner is the temperature your running at....
- Fri Jan 25, 2013 1:46 pm
- Forum: Lambretta Dyno Graphs
- Topic: A BIT OF SIL 200 TUNING
- Replies: 23
- Views: 23616
Re: A BIT OF SIL 200 TUNING
hi Darrell its Kev here from Newcastle, I bought the LTH manifold off you, been looking through the dyno graphs and come across the SIL one you did, the e-bay ally 225 kit i used the LTH on has same port timings as the SIL barrel and i did pretty much exactly as you did for tuning,,my boost port is ...
- Wed Jan 23, 2013 5:55 pm
- Forum: Dealer News, Innovations & Products
- Topic: New Big Block Gran Turismo Kit 200-245cc
- Replies: 141
- Views: 62024
Re: New Big Block Gran Turismo Kit 200-245cc
cast iron or ally, any is good for me as long as its steel lined,,,,coatings are crap for any engine thats actually being used daily, especially with no air filter,,i know someones going to say..i had my TS 5 years and it dont need plating, well it probably does, even when not worn off it expands,, ...
- Mon Sep 24, 2012 6:18 pm
- Forum: Lambretta Tech
- Topic: stopping power for a Lambretta isnt limited to hydraulics
- Replies: 83
- Views: 31604
Re: stopping power for a Lambretta isnt limited to hydraulic
AF built me a scooter in the late 70s and he set the front brake up as reverse pull and i had no problems with it ever, the scooter was fast i was young and it stopped on sixpence, this might seem daft, but at times the drum brakes seem better when set up properly to a disk which can catch you out a...
- Mon Sep 24, 2012 2:03 pm
- Forum: Lambretta Tech
- Topic: Removing Cylinder Studs
- Replies: 9
- Views: 3657
Re: Removing Cylinder Studs
heat then get some nitrogen and freeze them for the nitrogen supply i use computer key board cleaner, wilkinsons (the shop that sells crappy plastic things and paint) sell it for 2 quid a can,hold can upside down and spray it. the nitrogen propellent comes out at about minus 20 and the frost is inst...
- Tue Sep 18, 2012 7:35 pm
- Forum: Lambretta Tech
- Topic: Lambretta Flywheel Woodruff key sheared in half
- Replies: 23
- Views: 12127
Re: Lambretta Flywheel Woodruff key sheared in half
when you refit the new key, take some time and lap the crank to the flywheel it makes sense, last time i sheared a key (about 79) i cut the corners off a sixpence with a pair of pliers and a brick as a hammer and wedged two bits in. it got me home to newcastle from bridlington <(i think), ever since...