Works out final ration 4.57.
[/quote]
I think I ended up with 46x18 but I can't remember! Should of written it down
5 speed box fitting tips
-
alanscottj
- registered user
- Posts: 960
- Joined: Fri May 23, 2014 6:54 pm
- Main scooter: Lambretta GP SS250 Casa
- Contact:
Think I ended up 20-47.
Works out final ration 4.57.
[/quote]
I think I ended up with 46x18 but I can't remember! Should of written it down
Works out final ration 4.57.
[/quote]
I think I ended up with 46x18 but I can't remember! Should of written it down
Lambretta Series 2 Rat - RB260, SuperTourer, Cyclone 5 gearbox 😎👍
-
Fux
- registered user
- Posts: 501
- Joined: Mon Aug 17, 2009 9:42 pm
- Main scooter: li150 S2
- Location: Norway
- Contact:
Fellas,
I`m fitting my 2nd cyclone 5.
Did you use the little shim that fits between layshaft and bearing in the endplate?
also, damn the splines on the gear cluster have a realiy tight tolerance! I have to use a 3 pronged puller to get my LTH cluch off.
I`m fitting my 2nd cyclone 5.
Did you use the little shim that fits between layshaft and bearing in the endplate?
also, damn the splines on the gear cluster have a realiy tight tolerance! I have to use a 3 pronged puller to get my LTH cluch off.
-
Fux
- registered user
- Posts: 501
- Joined: Mon Aug 17, 2009 9:42 pm
- Main scooter: li150 S2
- Location: Norway
- Contact:
Job done.
Piece of cake with the granturismo endplate and octipus layshaft.
Ended up with 1mm gear shim, no shim under the layshaft and no shim over the gear cluster.
Fingers crossed. haha
Piece of cake with the granturismo endplate and octipus layshaft.
Ended up with 1mm gear shim, no shim under the layshaft and no shim over the gear cluster.
Fingers crossed. haha
-
dirtyhandslopez
- registered user
- Posts: 465
- Joined: Sun Mar 22, 2009 5:15 am
- Location: Richmond Virginia, USA
- Contact:
Not expert by any means, but I would think that if a groove is machined, the gear would be very thin where you machine the groove, making it weak..psychedelicropcircle wrote: ↑Mon Jul 31, 2017 1:30 pm ^thats the one I've just fitted was a little surprised the ribbed side didn't have oil slots in them, perhaps an expert might know as to why?
That's not going anywhere...