Dyno Please

General scooter chat, any scooter related non technical info.
shilloboxer
registered user
Posts: 30
Joined: Tue Jan 13, 2009 12:01 pm
Contact:

I need two smallframes dynode in the midlands but willing to travel to get them set up properly. I have had them done locally but they are running very lumpy and rich.
User avatar
DigDug
registered user
Posts: 788
Joined: Wed May 02, 2012 1:00 pm
Main scooter: Lambretta
Location: Stroud
Contact:

Jerome @ Readspeed. Stourport on Severn
Did you have to do that?
shilloboxer
registered user
Posts: 30
Joined: Tue Jan 13, 2009 12:01 pm
Contact:

Yes used Jerome before and they were running very rich and lumpy.
User avatar
Toddy
registered user
Posts: 6095
Joined: Sun Mar 08, 2009 12:01 am
Main scooter: Lambretta Series 1
Location: East Yorkshire
Contact:

shilloboxer wrote:Yes used Jerome before and they were running very rich and lumpy.
Why not take them back and explain to him if you was not happy ?
As my Dad used to say "Each to their own lad"
shilloboxer
registered user
Posts: 30
Joined: Tue Jan 13, 2009 12:01 pm
Contact:

Its not the fact I wasn't happy they were new builds and Jerome always runs them rich which is why I left it last season. I wouldn't slag him off because he's good at what he does. Hence the reason i've asked the question
B-Race Tuning
registered user
Posts: 246
Joined: Sat Dec 29, 2012 5:07 pm
Main scooter: Lambro, GP.
Contact:

If that's the only reason it's lumpy, and that reason being totally acceptable, then you should contact Jerome and book it in. He built them and knows what he's doing. I'd even be surprised if you get much of a bill, if any. Simon.
Post Reply Previous topicNext topic
  • Information
  • Who is online

    Users browsing this forum: No registered users and 2 guests